Brief Introduction Of 1100 aluminum alloy :
1100 aluminium alloy is an aluminium-based alloy in the "commercially pure" wrought family (1000 or 1xxx series). With a minimum of 99.0% aluminum, it is the most heavily alloyed of the 1000 series. It is also the mechanically strongest alloy in the series, and is the only 1000-series alloy commonly used in rivets. At the same time, it keeps the benefits of being relatively lightly alloyed (compared to other series), such as high electrical conductivity, thermal conductivity, corrosion resistance, and workability. It can be strengthened by cold working, but not by heat treatment.
Machinability:
Aluminium/Aluminum 1100 alloy has excellent machinability especially when the alloy is machined in hard temper. Carbide tooling is suitable, but high speed steel tooling can also be used. In cases where heavy cuts are required, an oil lubricant must be used.
Forming:
Both hot and cold forming is easy to perform with Aluminium/Aluminum 1100 alloy. This alloy can be cold worked extensively in the annealed condition without the need for intermediate annealing.
Welding:
Welding can be easily performed using all the conventional methods. It is suitable to use AL 1100 consumable electrodes and filler wire for the process.
Heat Treatment:
Aluminium/Aluminum 1100 alloy cannot be successfully heat treated other than to produce the annealed form and 'O' temper.
Forging:
Aluminium/Aluminum 1100 alloy can be hot forged without much difficulty.
Hot Working:
Hot working can be easily performed on Aluminium/Aluminum 1100 alloy.
Cold Working:
Aluminium/Aluminum 1100 alloy is best suited for cold working as it has good ductility in the annealed temper condition. It can also be cold formed by bending, drawing or spinning.
Annealing:
After Aluminium/Aluminum 1100 alloy is extensively cold worked, annealing is required and can be performed at 343°C (650°F) for a suitable amount of time so as to ensure thorough heating and then it can be air cooled.
Product Attributes:
*Temper: O/T4/T5/T6/T651/T351/H11/H14/H32/H24 etc.
*Thickness: 0.5mm-600mmmm
*Width: 100mm-3800mm
*Length: As requirement
*Surface: Mill Finish, Oxidized,Mirror Finish,Sliver,Black, etc.
*Mill Certificate: EN10204/3.1
*Payment: T/C, L/C
*Package: Wooden Package, less than 2 tons per cases
*Delivery time: Normally 15 working days